Aquarium Illusions Inc 17211 - 107 ave NW

  • FREE Local DELIVERY on Orders over 115
  • 17211 107 Ave NW Ph: 780-483-7027 or 1-800-559-6546
  • Shop In Store: M-W 10-6, T-F 10-8, Sat 10-6 Sun 11-5
  • |
  • |
  • Register

Neptune Systems Liquid Level Sensor 35" (LLS)

C$156.99
Availability: Out of stock

Sold out

... updating the shopping cart ...
Add to wishlist
  • FREE Local DELIVERY on Orders over 115
  • 17211 107 Ave NW Ph: 780-483-7027 or 1-800-559-6546
  • Shop In Store: M-W 10-6, T-F 10-8, Sat 10-6 Sun 11-5

Never before offered in the aquarium industry the LLS Sensors allow for the measurement of water depth in inches or centimetres. Each sensor has a special place in helping understand the water level in the sump, aquarium, reservoirs, and other liquid-holding containers.  No longer does one need to physically look to observe how much water level is above or below a specific point, but now simply open the Apex Fusion App and observe.

How does it work??

The LLS sensor can connect to any available FMM port in the Apex System.  Liquid will enter the plastic envelope around the thin material of the sensor.   Once the liquid is in contact with the sensor material the LLS uses a patented resistive sensing technology to accurately and reliably measure the liquid level in a container.

How do you install it?

Included with each LLS sensor is a clip that allows for the mounting of the sensor to the side of the sump, aquarium or container.  Have a Euro braced sump?  Don’t worry you can simply mount the LLS sensor to a baffle inside the sump.

The LLS’ wire is 3 meters in length.

Later in 2022 Neptune Systems will release a magnetic version of this clip and a clip that mounts to a euro-braced sump or aquarium.

How responsive is it?

Generally the sensors respond to liquid level changes at a rate of about fifteen seconds per inch of water level change.  So if the water level was suddenly decreased three inches, then it could take up to forty-five seconds to reflect this change.  While quick depth level changes are uncommon in an aquarium, and, typically, changes  are reflected more quickly than this, for this reason, it is best practice not to use the LLS for immediate control needs— like auto top-off control.

How accurate is it?

Once calibrated the LLS is accurate to about two-tenths of an inch.

Why 35"?

The largest of the LLS sensors is the 35″ sensor.  This sensor is to be used for large reservoirs that are often utilized for saltwater reservoirs for manual and automatic water changes.

Is it SUBMERSIBLE??

Yes and no.  The sensor aspect (the white ruler section) is obvious suppose to be in your water to measure depth!

But also no– The components in the head of the LLS are fully encapsulated in epoxy, but the LLS is not intended to be fully submerged. Care should be taken when selecting the proper length of LLS and installing it to ensure that the water level never exceeds the uppermost graduation mark.

No specifications found

  • EAN 653078004830
  • Weight 160
  • Size X 111
  • Size Y 15
  • Size Z 5
No reviews found...

Sign up for our newsletter

Social media

© Copyright 2024 Aquarium Illusions Inc 17211 - 107 ave NW - Powered by Lightspeed - Theme by totalli t|m e-commerce
Authorize.Net Merchant - Click to Verify